Recently I had the same problem with Qashqai 2008 - Still not sorted
Usually problem is faulty central lock on drivers door
hi, had a customer today call me out
remote central locking stopped working,
he has spare remote key which has never been used - customer had car from new - also not working.
1. i tried frequency output both remotes - fine
2. i tried diagnostics on bcm unit - no fault codes
3. i tried battery disconnect and pulled all the fuses in the interior box where obd socket is
4. central locking button functions inside the car fine
what coud this be? it was all of a sudden, customer came out from shop and remote didnt work.
Tools owned -
AD100 PRO, Lonsdor, FVDI 18, FVDI 20, VVDI PROG, VVDI2, VVDI MB
CGDI BMW, SuperVag, Renault ECU tool, OBDstar X300 DP Plus, AUTEL im508
VVDI Mini Keytool, KeyDIY KDX2, SBB, ACDP CAS/KVM
Opcom, VCDS pro, Diagbox, Multiecuscan, Forscan, JLR SDD
Recently I had the same problem with Qashqai 2008 - Still not sorted
Usually problem is faulty central lock on drivers door
sdnatlst (18th June, 2019)
Nissan cars Note/Qashqai has issue with remotes suddenly stopped working rumours you will need a new control unit!!!
Tools owned: Hammer, Chisel, Crowbar, Punch, Chainsaw, Cutter and Brain!!!
Did you know People will question all the good things they hear about you but believe all the bad without a second thought.
Note:All information given is to be used for educational purposes only and should not be taken seriously.
sdnatlst (18th June, 2019)
Yes i told customer to take it to Nissan as i suspected issue with BCM,, so sounds like my advice was right.
thanks all
Tools owned -
AD100 PRO, Lonsdor, FVDI 18, FVDI 20, VVDI PROG, VVDI2, VVDI MB
CGDI BMW, SuperVag, Renault ECU tool, OBDstar X300 DP Plus, AUTEL im508
VVDI Mini Keytool, KeyDIY KDX2, SBB, ACDP CAS/KVM
Opcom, VCDS pro, Diagbox, Multiecuscan, Forscan, JLR SDD
super jumbe (18th June, 2019)
also caused by faulty ignition , when car doesnt see ignition is fully switched off . had this on a 2011 quashqai , remote not working and wouldnt allow me into programming mode , after new ignition all was fine. the give away was no warning beep when key in ignition and door opened .
Last edited by rapidlocksmiths; 18th June, 2019 at 11:31 PM.
Disconnect plug from switch that tell you key is in ignition and remote should work again.
Thanks
I tried this on Qashqai without success
Today I conected autocom to Note (on this car remote work OK) and in BCM I saw that has options to check remote
then I connected auttocom to Qashqai and there no conection with BCM
So in this case Super Jumbe maybe is right
Can I directly swap the BSM with second hand or must be virgin and coded?
sound like jumbe i am hang on with it
Micra K12 - faulty ignition key switch. After unplug connector remote work again.
Bookmarks