New connect 2015 akl with alarm

[instakeys]

This is 80bit ID63 system. Vehicle is a Limited model with active alarm. Is key programming possible? Or need new bcm?

Ive done other new connect models with no alarm easy job. Are these like Transit Custom if alarm active no programming possible? Has anyone tested. The van is miles away and I’d rather know by morning if it’s a waste of time even going

thanks and rep for those who can assist

[jodge]

worth a try
https://www.digital-kaos.co.uk/forum...=1#post3544341

or this:

ALARM ACTIVE PROCEDURE (ALL KEYS LOST)
1. TAPE OVER ALARM/ULTRASONIC SENSORS IN ROOF.
2. ENSURE ALL DOORS/TRUNK/HATCH/BOOT ARE CLOSED.
3. ENSURE NEW KEY IS IN THE IGNITION AND ON READY TO PROGRAM.
4. PROGRESS UNTIL YOU ARE AT THE POINT TO PROGRAM THE KEY.
5. WAIT FOR THE DOUBLE HORN TO SOUND (APPROX 8 TO 16 MINS).
6. AS SOON AS THE HORN SOUNDS TWICE PROGRAM THE KEY.

NOTE : THE TIME TO PROGRAM THE KEY IS 1 MINUTE ONCE THE HORN SOUNDS.
NOTE : IF YOU TRIGGER THE ALARM, THEN VEHICLE RESETS AND YOU MUST START AGAIN.
NOTE : THE ALARM WILL STOP SOUNDING AFTER 5 MINUTES, BUT HAZARDS WILL CONTINUE TO FLASH.