some times you have to keep trying. some time will work second or third time.
Guys,
I have this situation. 01/18 Jeep Wrangler ( Smelecom DSP3+)
I tried doing it OBD2 with the SGW/CGW bypass, I was able to do PCM/SRI miles
I was not able to do the cluster, I tried Chrysler wrangler menu , would not read
So I tried everything else under chrysler/Fiat/Alpha, and it read under chrysler pacifica 2017-UP menu, reads correct miles but does not allow to write, gives error "0075 failed to access 2 "
So I took the cluster out, looking for a 95320 chip, not there, looks eeprom-less. I see a microprocessor R7F701422.
Then I compared the cluster to other chysler clusters, and found that it looks similar to dodge charger, and smelecom gives pictures how to connect direct to the cluster and program ( +12, grnd, can+,can- and 100ohm-1k resistor)
I did that, would not read with 100,120 or 150 ohm resistor between pin 12-13 under the charger or pacifica ( pacifica read obd2) menu
So I went with 330 ohm resistor, now I'm able to read under pacifica menu, just like I did by obd2, but it still does not allow me to write.
any ideas....
some times you have to keep trying. some time will work second or third time.
DON'T JUST SAY PRESS IT.....
I did, did not work for me this time
Hi DK,so i have same issue than norbisko same cluster Wrangler JL 2018 ,i try with DSP3+ by obd2 and i can read choose pacifica and ram 2018 but i can't write milage so i open it back of cluster under heatsink tssop 95320 so i have dificult to read with pogo plug the pins hare loose and not touch correctly so i just retest and leave infos,thanks.
this one use the CAN-C bus trough HUB port in order to be done by OBD II
https://www.youtube.com/watch?v=n6wAbGWWTCQ
starmobile (29th October, 2019)
Bookmarks