Ned eeprom and flash BCM2
Ned eeprom and flash BCM2
VIN:WAUZZZ8T99A029310
CS:5EEC5F2AB45CE7
MAC:2F9500E8
PIN:52921
Immo Type:Immo 5
vosje1 (12th August, 2019)
Tunelab thanks i am going to try programming it.
Best regards Vosje1
Last edited by vosje1; 12th August, 2019 at 05:11 PM.
Unfortunatly it didnt work the car dosnt start. now i will try to make immo off and hopefuly the car will run again. I hope this file will work for this edc17cp14 ecu
you must adapt the component protection for the new cluster.
read the data from gateway (eeprom) with a programmer then install the gateway, back to the car and load the file under your fvdi - special functions -component protection
now fvdi adapt the component protection and the car start.
best regards
Last edited by J328D; 12th August, 2019 at 07:03 PM.
Thanks everyone i found the issue, its not the immobilizer thats causing the non starting problem like the dealer said but its the injector driver thats at fault. So i have to find me a donor ecu.
Cluster and key learning went well.
Best regards Vosje1
Last edited by vosje1; 13th August, 2019 at 09:57 PM.
Hello ones again,
Still can't clone the new ecu that i bought my avdi said failed every time but its suposed to do the clone function. So can someone help me with making the clone file so i can try the new ecu in the car?
Original file are posted in the first post, these are from the donor ecu. Thanks in advance.
Best regards.
Last edited by vosje1; 19th August, 2019 at 08:25 PM.
And here is the picture of avdi.
2019-08-20_113159.jpg
Please test
Thanks Nevidimka i"ll try and report back. And what tool is that you use for this?
Best regards.
The data is correct but can't communicate anymore with the ecu and i realy dont know why so i have to find that out before i can try to match the ecu to the car.
Thanks.
Bookmarks