Reply With QuoteNo problem m8,what about measurements?
Results 16 to 19 of 19
-
22nd August, 2019, 09:30 PM #16DK Veteran
- Join Date
- Oct 2017
- Location
- HELLAS - E.U.
- Posts
- 3,109
- Thanks
- 681
- Thanks
- 785
- Thanked in
- 642 Posts
-
23rd August, 2019, 07:59 PM #17Top Poster +
- Join Date
- Feb 2010
- Posts
- 223
- Thanks
- 32
- Thanks
- 116
- Thanked in
- 80 Posts
-
23rd August, 2019, 08:16 PM #18DK Veteran
- Join Date
- Oct 2017
- Location
- HELLAS - E.U.
- Posts
- 3,109
- Thanks
- 681
- Thanks
- 785
- Thanked in
- 642 Posts
i cant find anything wrong......
i try to find an other flash and test it on board....
-
23rd August, 2019, 08:33 PM #19Top Poster +
- Join Date
- Feb 2010
- Posts
- 223
- Thanks
- 32
- Thanks
- 116
- Thanked in
- 80 Posts
As long as it can be read or write flash should be ok.it does not matter if it is in programmer or in ecu,same operations take place.if programmer can read it then the mcu can read it.for that ecu to boot you need a good power supply,a good processor,good ram if it requiers,pcb to be in good condition and a good sw.do you have an oscilloscope?power supply ic i think is u304,i cant see very well that part of the board.from there you start troubleshooting.
-
The Following User Says Thank You to cristi_bv For This Useful Post:
Panathaole (25th August, 2019)
Bookmarks