You have bad tuning and no checksum, try this and report!
Hello.
I have MPPS and I can read my original file from the car fine.
I've had the file tuned/modded, but when It comes writing the modded file back onto ecu, at 99% It's prompting me with "conditions not met".
I'm able to flash my original file back on fine, but the tuned one is a no go...
I'll attach both files.
Thanks and I appreciate any help!
You have bad tuning and no checksum, try this and report!
If I helped you, click thanks and reputation
samde95 (21st August, 2019)
What could be causing it to not start? Its writing onto the car fine but not starting.
once the original file is back on its fine.
Hi mate,
Your mod file have wrong checksum.No doubt.MPPS can't do the checksum in writing.
a500tut user is right, no checksum and bad tune.
you have modified "monitored maximum torque at clutch" map,"scaling factor for requested torque at clutch from driver"map, "limp home value of maf with throttle position diagnosis error" map,"setpoint mass air flow depending on slow torq"map,"catalyst exhaust gaz temperature in steady state"and so on.No fuel map touched, no spark map touched,nothing good in your mod file.If you write file provided by "a500tut" user car will start.Don't play with gasoline engine without knowledge, can melt pistons in a minute.
Real engines don't need forced induction
Who needs a turbo when you have a stupidly quick naturally aspirated engine?
Hi, would you be able to checksum this new file for me?
Bookmarks