BMW E46 316ti ME9.2 READ WRITE over BDM100

[alldecode]

Solutions to Read and Write ME9.2 over BDM100

problem is when Write, on 99% stay and not finish

Use BDM conections

and solder resistor 120 ohm between +5V and BOOT pin like picture

BMW ECU.JPGBMW board.JPGBMW boot.JPG

Please PUSH thanx if post is help.

Regards

[bonecrusher]

Very interesting, although I never had to do this just read directly from the BDM

[alldecode]

and this is my first bmw like that too, but after this resistor sucess to read.

[SALAS]

I did this ECU many times in the past with FGTECH and generic EDC16 BDM adapter with no problem
Anyway good info, but I think BDM100 doesn't work fine any good tool can read/write this ECU

[rocodou]

just pull out a resistor and a bridge

100% solution

[alldecode]

clone this ecu, and car start, then is good read and write