In short, no sure, put volt meter on pressure sensor vague idea 1volt per 100 bar
if you stall engine does pressure drop like a stone? Could be injector
deffo use another diag tool
In short, no sure, put volt meter on pressure sensor vague idea 1volt per 100 bar
if you stall engine does pressure drop like a stone? Could be injector
deffo use another diag tool
Was Banned For Being Certifiably Insane and Stupid
teerak2uk (21st August, 2019)
Pressure fluctuates but volt always shows 2.59v
Last edited by teerak2uk; 21st August, 2019 at 10:23 PM.
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
OFF TOPIC:-
had a car in once, for O2 sensor fault, unplugged both sensors, live data showed them both working correctly, had it before
and since where ecu displays what it expect and what it gets.
ON TOOIC:-
connect osliscope to sensor and regulator.
is it supermarkets fuel all the time?
Was Banned For Being Certifiably Insane and Stupid
teerak2uk (22nd August, 2019)
Looks like high pressure pump or component on the pump like DRV breaking down .
try cleaning out drv etc also check a wiring diagram see if any two components share feed or earths etc
Today is the Tomorrow you worried about yesterday ......Was it worth it ?
teerak2uk (22nd August, 2019)
Check fuel temperature sensor and wiring. Wrong pressure may be consequense wrong temperature.
teerak2uk (22nd August, 2019)
I agree with mr meaty, do a back leak test on injectors. Pump could be low, then when it fires pressure goes through the roof.
Fuel injectors
teerak2uk (22nd August, 2019)
Bookmarks