Reply With QuoteCan someone confirm if this is working?
Results 1 to 3 of 3
-
23rd August, 2019, 08:39 AM #1Junior Member
- Join Date
- Feb 2015
- Location
- London
- Posts
- 38
- Thanks
- 19
- Thanks
- 3
- Thanked in
- 3 Posts
2008 Peugeot 308 BSI direct communications pinout needed
I have a problem with no communications on a 2008 Peugeot 308, 1.6 petrol.
Car starts and runs fine.
Diagnostics shows ECU, ABS etc but no comm to BSI.
CAN comms to OBD seems to be ok ... I need direct wiring to BSI for comms, power, GND, can H, can L, k-Line.
Reason: car has been recovered after being stolen, has one working key, need to erase all keys and program 3 new ones.
Thanks
-
23rd August, 2019, 09:03 AM #2Junior Member
- Join Date
- Feb 2015
- Location
- London
- Posts
- 38
- Thanks
- 19
- Thanks
- 3
- Thanked in
- 3 Posts
-
23rd August, 2019, 09:08 AM #3Top Poster
- Join Date
- Mar 2012
- Location
- Belgrade
- Posts
- 196
- Thanks
- 55
- Thanks
- 77
- Thanked in
- 55 Posts
I think Your BSI is in sleep mode.
Try this steps...turn ignition ON,than turn OFF,wait 3minutes,disconnect battery,wait 15sec,but clam on,wait 10sec. Put down turning signal (left or right,doesn’t matter) than turn ignition ON and You should have comms with it.
Did that exact same thing yesterday with exact issue.
Sent from my iPhone using Tapatalk
-
The Following User Says Thank You to dooshan For This Useful Post:
PocketHero (23rd August, 2019)
Bookmarks