Peugeot 206 1.4 petrol ECU SWAP

**jackie86** · 21st September, 2019, 02:38 PM

Hi friends. Need to swap ecu for this car. Have one VALEO and one Jonson Control. Take a look at picture..

IMG_3555.JPG
Does this two are compatible? How to swap ?
Thank you in advance.

Sent from my iPhone using Tapatalk

**jackie86** · 21st September, 2019, 07:29 PM

No one could help?
Is it possible to make virgin Jonson Ecu?
Or maybe to swap eeproms?

Sent from my iPhone using Tapatalk

**rafal** · 21st September, 2019, 07:37 PM

swap eeprom and u will see................

**jackie86** · 21st September, 2019, 07:37 PM

Originally Posted by rafal

swap eeprom and u will see................

Very helpful......

Sent from my iPhone using Tapatalk

**jodank** · 22nd September, 2019, 10:02 AM

Hi!
I'm not sure does these two are compatible cos I always use the same type of ecu when I have to swap.

Regularly the eep swap should be enough to swap the ecu but this is also the case when you use the same type of ecu.

Of course there are some compatible ecu's too but I never tried to play whit it.

Conclusion:
Your swap could work but you could have also some alian behavior of the engine and the most dangerous situation could be if you use the original eep ic ( desolder - solder ) the donor ecu could maybe kill the content of the original eep.
So, make a backup first of the eep and then put it to the donor ecu.

It is up to you, do you wish or not to spend a bit of your time to check and pls report the result.

I hope I helped a bit.
My best regards.

Sent from my SM-J500F using Tapatalk

**jackie86** · 23rd September, 2019, 02:09 PM

Originally Posted by rafal

swap eeprom and u will see................

You were right, eeprom swap solve problem.
I gave you apologize.

Sent from my iPhone using Tapatalk

**jackie86** · 23rd September, 2019, 02:10 PM

Originally Posted by jodank

Hi!
I'm not sure does these two are compatible cos I always use the same type of ecu when I have to swap.

Regularly the eep swap should be enough to swap the ecu but this is also the case when you use the same type of ecu.

Of course there are some compatible ecu's too but I never tried to play whit it.

Conclusion:
Your swap could work but you could have also some alian behavior of the engine and the most dangerous situation could be if you use the original eep ic ( desolder - solder ) the donor ecu could maybe kill the content of the original eep.
So, make a backup first of the eep and then put it to the donor ecu.

It is up to you, do you wish or not to spend a bit of your time to check and pls report the result.

I hope I helped a bit.
My best regards.

Sent from my SM-J500F using Tapatalk

Thank you for your answer.
Eeprom swaping solved this problem.
Thank you all.

Sent from my iPhone using Tapatalk