As soon i get home i check my files mate..i let you know
As soon i get home i check my files mate..i let you know
immokill (11th October, 2019)
After trying to read ecu on bench with KTag first error was micro can not be read and after 3times ktag says ecu connection check! Now car wont start no engine lamp . What could happen ? I will get used ecu same soft and ecu number .
But why ktag blicked my ecu . Is eeprom problem or micro? Please help if someone has same situation
Thanks
I think ecu brick only when writing and not on reading...do u conect 12v on right place?
What u have on power suply?
From Now you are ECUKILL
LOL.
Powe suply was ok . I did this and other type of edc17 on bench many times . This is first time that ktag reject to read . Evryrhing was like in manual . CanL canH power ground all ok . Grey and blue aligator on place . It was just no response from ecu .
Sent from my TELEFON
here mate...read by magpro
edc17c46?
Last edited by rfernandes; 11th October, 2019 at 09:55 PM.
immokill (17th October, 2019)
Realy strange..good to know the cars its ok
immokill (14th October, 2019)
Yes but I wil l change this ecu , it is not safe to give friend car with this situation .
Safet to put used good ecu i'm not 100% sure that it will not lost communication somewhere on the road .
I will post new threat about cloning immo data from this to used ecu .
Galleto will read ecu i add to basketb new ktag and kess suite 2.47 .
Regards and Thanks
Bookmarks