Bosch EDC15VM+ EGR Removal

[henson12345]

Hi,

i fitted EGR blank plates to the Audi today. It has a EDC15VM+ ecu. Downloaded file with my kess clone. Can I turn EGR off using EDC suite or do I need to use Titanium or WinOLS?

Do these work same as EDC15p?

thanks

[naskochipa]

Hi,

i fitted EGR blank plates to the Audi today. It has a EDC15VM+ ecu. Downloaded file with my kess clone. Can I turn EGR off using EDC suite or do I need to use Titanium or WinOLS?

Do these work same as EDC15p?

thanks

Post your file
Post your filePost your file

[henson12345]

Hi, will need to post tomorrow as at work now.

is it same as 15P where you raise HEX to highest level and that’s it?

Post your file
Post your filePost your file

[henson12345]

How can I adjust this one myself please?

[antimon95]

You can easily fill values with max value on egr map, use vagsuite tool. Or use ecm titanium and look for phase of injection, also fill whole map with max value.

[henson12345]

Thank you Sir! As I have blanked off EGR due to it being stuck, as opposed to just mapping it out to leave it closed, will this sort any error codes that may come up?

You can easily fill values with max value on egr map, use vagsuite tool. Or use ecm titanium and look for phase of injection, also fill whole map with max value.

[henson12345]

Hi,

So increased all the EGR map values to max and I'm getting a couple of EGR related fault codes How do I map these out??

[DiegoStud]

arwMEAB0KL, arwMEAB1KL- 2 maps both 20x1 not far after EGR base map.
They are hysteresis maps for activation/deactivation of EGR function depending on injected fuel quantity. Axis is RPM and map is IQ. Set IQ to zero in both and leave the EGR map alone

[antimon95]

Hi,

So increased all the EGR map values to max and I'm getting a couple of EGR related fault codes How do I map these out??

Increased to maximum means only fresh air coming to cylinder on whole map. Did you remove fault codes with some diagnostic tool?