Peugeot 407 bsi HELP

[Zmann]

Yes, I did.

[VMarkov]

Hello, the situation with our Peugeot continues.
I was preparing a BSI from diesel (it only provided ACC). I downloaded the information from the original BSI (95128) and copied it to EEPROM of the new BSI. And …… it doesn't even give ACC anymore. From the original I easily got the VIN and code, but it seemed to me that the run was 0 kilometers. Is it damaged?
Any ideas and suggestions?
This is the original file.

[VMarkov]

This is original.

[banelab]

Go virgin from ecu take pin code and diagbox-it��

[systemlinux]

Touching a BSI is a deadly, very sensitive effect.


Better IMMO OFF ECU or program key getting the pincode and virginize the file again.


To configure the BSI you must have DIAGBOX (official PSA software).

[VMarkov]

I thought to put the new BSI with his file, to put the ECU file without immo. The problem is that the ECM does not start with the new BSI at all. I watched IAW 6LPB give ACC through the CAN.

[Tachodiag]

Put ecu + bsi + key from donor vehicle if you have no clue ...