2015 VW Jetta Keyless - serv mode - jump cluster??

[mojomojo]

Hello folks
I am working on a
2015 VW Jetta
keyless system
nec 24c64 2014.6+ system
dash # 5C6920954B
I have a dealer key.(assuming precoded to immo data)

I am using vvdi2. I followed all instructions till I put the dash back in service mode.

is the dash suppose to turn on when i hit the push start button?
do i need to jump like older models?
I cant find diagram for this year.

[qeso705]

Same as older one.
Pin 7- Immo Coil
Pin 8- Immo Coil
Pin16- GND
Pin28- CAN High
Pin29- CAN Low
Pin31- 12V
pin32- 12V

[mojomojo]

Same as older one.
Pin 7- Immo Coil
Pin 8- Immo Coil
Pin16- GND
Pin28- CAN High
Pin29- CAN Low
Pin31- 12V
pin32- 12V

thats the cluster plug..

i need to know what to next after dash epp put on service mode.

i install dash back and press start button and nothing happens!
do i need to jump fuse box?

[qeso705]

Make connection on desk, when you do it on car most likely you lost abs coding. After you get immo data you go to keylearn option and just learn dealer key, when i remember good it will ask you its keyless or not.

[mojomojo]

Make connection on desk, when you do it on car most likely you lost abs coding. After you get immo data you go to keylearn option and just learn dealer key, when i remember good it will ask you its keyless or not.

i saved abs coding and disconnected abs ecu plug like i have done in the past.. thank you for advice


i dont have harness to finish on bench.

all I am asking is how to jump cluster within vehicle?

[qeso705]

Bridge 1 and 16 in obd2 socket but make full vcds scan first to avoid lost codings.

[mojomojo]

Bridge 1 and 16 in obd2 socket but make full vcds scan first to avoid lost codings.

did not work...is the cluster suppose to to turn on once these are bridged?

[qeso705]

did not work...is the cluster suppose to to turn on once these are bridged?

You have bridge all the time? There is communcations with clusters?

[mojomojo]

You have bridge all the time? There is communcations with clusters?

thank you very much...i was able to complete the programming.. i wiggled the female plug of my obd breakout box and it turned on..