Search for best tool to read and write EDC17C46

[quadral]

I want to clone a edc17c46 ECU just for my pleasure and doing it myself.
Do you have any suggestions that are still affordable?
This ist not my business so a cheap (but good) clone ist preferred.

First research.
KTAG Version ???
KESS Version ???
MAGPRO X17 ??? - Clone exist?

[gas43]

I want to clone a edc17c46 ECU just for my pleasure and doing it myself.
Do you have any suggestions that are still affordable?
This ist not my business so a cheap (but good) clone ist preferred.

First research.
KTAG Version ???
KESS Version ???
MAGPRO X17 ??? - Clone exist?

https://www.digital-kaos.co.uk/forum...d-tool-for-obd

[figani]

I want to clone a edc17c46 ECU just for my pleasure and doing it myself.
Do you have any suggestions that are still affordable?
This ist not my business so a cheap (but good) clone ist preferred.

First research.
KTAG Version ???
KESS Version ???
MAGPRO X17 ??? - Clone exist?

until now, they don´t clone mm products...
with kess clone it´s posible, but a lot of useres cry after done work ecu dead...
ktag, some users write that a rework is required others write that they have succesfully done without a rework...

check pcmflash SW module 71 is still cheap compared to the big player...

[quadral]

The Site https://ecutools.eu/chip-tuning/pcmflash/ list module 50 to work with EDC17C46.
The module is offered at 151 Bucks.

What do I need else to use module 50?

Could a USB/ODB2-Interface J2534 really read the ECU?

[figani]

The Site https://ecutools.eu/chip-tuning/pcmflash/ list module 50 to work with EDC17C46.
The module is offered at 151 Bucks.

What do I need else to use module 50?

Could a USB/ODB2-Interface J2534 really read the ECU?

For writing is this module, you can't clone and or read...
Read my post before...

[quadral]

Now I'm a little confused. If this module can only be used to write, what do I do to backup the old ECU?

[figani]

Now I'm a little confused. If this module can only be used to write, what do I do to backup the old ECU?

module 71 and or module 53 for booting,...
for a beginner it´s easier with 71, not need to open ecu...
you also need HW, for example scanmatik 2Pro...

or choose solution clone ktag, whole in one and cheap...

[quadral]

or choose solution clone ktag, whole in one and cheap...

This sounds good. But I still have a lot to read. At the moment there are still many open questions.
- Where to buy?
- EU or not EU-Clone?
- Red colour or any other?
- Rework needed?
- and so on ...

[ecu1234]

Hi, ktm bench ecu edc17c46 read and write flasch + eprom ok

[batja]

Ktag. 7.020 clone no Problem.. Read (Backup) and write.