1) tell doctor, to send car to morque with next paitent he kills
2) check wiring in door shut of the side not working
The case
a emergency doctor Audi Q5 my 2011 [ lefthand ] Stopp in Garage. The extern power are on org Plug in the car.
The next day the Fuse of power of the extern Charger is out.
now the car get no power on Kl15
the
dash is Not on
no Communication with AdR 05 ( Ezs ) and BCM 2 with esp and a lot of other
the daylight is always on. So in this case it seems the Kl15 is on
the right Doors you can close and Open with the Remote the left Doors you can Open with the switch in door the left not.
i check all fuses , they ok
i change the Ezs and Elv no success ( Elv is open networking )
does any m8 know this problem. Is it the Bcm2 in the bag right corner ? Or gateway. I have Elsa and wiring plan but there a lot of Option where the trouble is and the need the car quick. The problem is, that you dont can read the car full and not can read Adr. 05 Zugang und Startberechtigung
the Engine Start s and one sec later stopp . Immo I know
any m8 have this case before ?
fir any help or idea I thx
1) tell doctor, to send car to morque with next paitent he kills
2) check wiring in door shut of the side not working
Was Banned For Being Certifiably Insane and Stupid
doctore (10th December, 2019), JFR-Tuning (10th December, 2019)
If canbus shorted to battery wont talk
ir gateway module bad
Was Banned For Being Certifiably Insane and Stupid
McDowell (11th December, 2019)
Yes i thought the Same change the Gateway Module with a scrap second Hand.
no sucess
als Bcm2
and Board Module
Ezs / Elv
all without sucess. The only Modul you can read is ECU Engine and Gateway
Dash and Mmi are also dark. If i Push the Button on Dach i can read km
i Buy a Trecker and Sensor to Check wire.
and we have a Problem with the doors only left side. This dont open and close with remote. All other do it
so I think it is a short circuit in can on left side
Peel inner doorpanel back like a banna
Was Banned For Being Certifiably Insane and Stupid
No easy . You only must disconnect the connector on door and DOOR is unconect.
today I connect on outside of gateway a canlogger
we do this
Bookmarks