If I remember correctly , not sure to be honest , this ECU's had to be patched for old Kess in order to be able to write. So not sure you can flash back. Try to read ecu with KTAG.
Octavia EDC 17c64 and I would like more power. My kess v2 only has the option to save the file, and the ori file wants it to download the original. How do I do that?
Or unless someone has a file ready with stage1 ???
2014. 110kW.
Engine: R4 2,0L EDC
HW Ver.: 04L907309D
SW upg.: 04L906021DS 7544
Installation: EDC17 CB.06.07.01 C50.00
Thanks
Regards
If I remember correctly , not sure to be honest , this ECU's had to be patched for old Kess in order to be able to write. So not sure you can flash back. Try to read ecu with KTAG.
What sw version?
You have Kess clone?
Then you better ktag it
AUTOTUNER, FLEX ,X17, TRASDATA / NEW GENUIS AND ALIENTECH MASTER OWNER.
FULL SWIFTEC AND EVC RESELLER
FILE SERVICE FROM 8AM - 9PM 7/7
BAPRO 4WD DYNO
Yes he can do it with clone kess.Tested - works ok,just need ksuite 2.47
I have ksuite 2.08...
If I upload this file, the car will start?
My kess clone has only OBD write option, I don't have read option.
If I do not load the file properly, can I do recovery?
If you don't have a backup of the ECU , anything you try with that version of the clone is risky.
When working on such ECU is better to have a backup before you fool around. ... it's like that .. "you ~~~~ it , you pay it"
Buy cheap Ktag clone
Last edited by Myjector; 13th December, 2019 at 08:08 AM.
AUTOTUNER, FLEX ,X17, TRASDATA / NEW GENUIS AND ALIENTECH MASTER OWNER.
FULL SWIFTEC AND EVC RESELLER
FILE SERVICE FROM 8AM - 9PM 7/7
BAPRO 4WD DYNO
Does anyone have a connection description for connecting tricore kessv2?
Only KTAG (clone) can do tricore on EDC17C64
Kess tricore not support it
AUTOTUNER, FLEX ,X17, TRASDATA / NEW GENUIS AND ALIENTECH MASTER OWNER.
FULL SWIFTEC AND EVC RESELLER
FILE SERVICE FROM 8AM - 9PM 7/7
BAPRO 4WD DYNO
Bookmarks