Just curious, how did you manage to read this? Unsolder the 64 pins or use the rear solder points?
You know you can use Digiprog (Tahoe) and St47 to do this job easily, except the hours must be done manually.
Just curious, how did you manage to read this? Unsolder the 64 pins or use the rear solder points?
You know you can use Digiprog (Tahoe) and St47 to do this job easily, except the hours must be done manually.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
Marios80 (12th December, 2019)
Craprog clone is not a good tool for dashes, it will get you into trouble IMO.
No, that was not a typo.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
I have my digiprog at my other home so I'll try that for future reads. In the meantime could you see the bin I put up and adjust it for 110,000-115,000 miles?
Quick question, would you be able to tel me what the colors are? For example, which one is +5V, reset, ground, Bdm, etc....
Here, and hours corrected to 4400
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
Marios80 (12th December, 2019)
Marios80 (12th December, 2019)
Use the pic Clusters provided. It has all you need to know.
Marios80 (12th December, 2019)
Marios80 (12th December, 2019)
Bookmarks