2000 Ford F150 mileage

**Marios80** · 16th December, 2019, 12:30 AM

Originally Posted by Killer76

Should be included with your tool.

Open Carprog, Choose the MCU your reading , look at bottom left of page. You should see a manual tab.

Originally Posted by Killer76

Should be included with your tool.

Open Carprog, Choose the MCU your reading , look at bottom left of page. You should see a manual tab.

Thank you to both

**Marios80** · 16th December, 2019, 02:47 AM

Finally got time to mess with the carprog and the HC11 manuals. So for reference the masket set on the processor is E22B. Got most of the colors and points worked out but I need to figure out the PD0/RxD (Green) and PD1/TxD (yellow). Those colors are based on the carprog HC11 manual but when I look at the pinouts on Codecard the diagram says that Yellow is RX (pin 13) and Green is TX (pin 14). Seems the colors on codecard are switched. Should I go by the colors on the carprog manual or by the pic on Codecard?

**jomberykaso** · 16th December, 2019, 02:53 AM

Colors are colors only. Check signal continuity in your adapter according to codecard info. ...this is the important thing

**Marios80** · 16th December, 2019, 04:25 AM

I get the whole continuity thing but that still wouldn't tell me which pin is RX and which is TX.

**jomberykaso** · 16th December, 2019, 04:46 AM

TX : pin 14
RX: pin 13

I can't understand why you don't see this if you already have all pdf manuals of carprog....even with pictures, names and colors

**Marios80** · 16th December, 2019, 05:21 AM

Originally Posted by jomberykaso

TX : pin 14
RX: pin 13

I can't understand why you don't see this if you already have all pdf manuals of carprog....even with pictures, names and colors

I can see the manuals, pictures, names and colors but that was my confusion and why I posted my question. My post asked if I should go by the carprog manual or the the carprog pin pic from Codecard. The manual didn't tell me which pin TX or RX is and the colors were different than on Codecard. By your response you answered my question. I should use the the pic of codecard. That's all you had to say.....

**mrkyboy** · 16th December, 2019, 07:38 AM

If yu have problem with reading disconnect red wire on A10 cable and plag in external +5v.I had that problem

**Killer76** · 17th December, 2019, 03:32 AM

This works for me....

**Fordtrucktexan** · 11th July, 2020, 06:46 PM

Can you inbox me pass

**mikroel** · 11th July, 2020, 08:32 PM

Because "Carprog Colors" I designed my adapters three years ago,
Now color doesn't matter, it's very easy to use.

I see that some guys have started copying my design,few months ago,and make advertising on the forum, ....

in any case a good adapter means a successful business.