Its fcuked, you need a new one.
got verdis gris init, get used from junkyard and swap eeprom
Hi everybody!
In a Land Rover Defender TD5 with MSB101171 ECU after a short circuit in the fuse box some of the tracks on the black connector were destroyed.I have not a schematic for this ecu and no pinout diagram to repair...
Does anyone have the pinout for black connector?
Its fcuked, you need a new one.
got verdis gris init, get used from junkyard and swap eeprom
Was Banned For Being Certifiably Insane and Stupid
i have checked everything is ok only some tracks from power connector have destroyed.I am trying to repair it and if not i will be looking for another one though it is hard to find
Must be thosands on eBay all nicked ones
Was Banned For Being Certifiably Insane and Stupid
It is easy to do immo off , or you can swap the eeprom , replace the unit !
i'm trying to find MSB101171 i dont know if other MSB.... is compatible
did you know for 1999 defender 2.5 td5 compatible ecus?
I have find MSB101191.Did anyone knows if is compatible with MSB101171?
most msb modules will work unless it came off an automatic then the answer is no
replace the flash and eeprom if you want it to be exact
ROVER MSB1011171 1999 defender 44pin A0016 LDMAN41 A0015 0541
ROVER MSB101170 A0016 LTMAN41
ROVER MSB000080 3190 A0016 LDMAN41
ROVER MSB101181 3438 1999 discovery 44pin A0016 LTMAN41
ROVER MSB101183 1999 discovery 44pin A0016 LTMAN41
ROVER MSB101184 A0016 LTMAN41
ROVER MSB101191 A0016 LTMAN41
ROVER MSB101193 A0016 LTMAN41
ROVER MSB101330 1999 discovery A0016 LTMAN41
ROVER MSB101340 AUTO discovery LT AUTO4145
Last edited by tango; 31st January, 2020 at 03:00 PM.
georgedigital (31st January, 2020)
Finally find MSB101191 swap the eeprom and car starts ok...After the car warm up trying to start and dont start...Take off same ecu from other car swap eeprom and same...What happened?I've started to go crazy...
sounds like immo problem
you would have best to change flash and eprom from broken ecu to new ecu
the plcc44's are otp so you have to remove and replace
Last edited by tango; 14th February, 2020 at 01:17 AM.
georgedigital (14th February, 2020)
Thanks tango i will do...I don't know if is easy to do immo off.I have try it with no success
immo off is easy post eeprom dump
but you need to replace the plcc44 with the one from broken ecu has it is different software
and then put the broken ecu's eeprom on new ecu and test
do you have diagnostics for td5 ie rovacom or nanocom?
Here the dump of eeprom.I haven't a diagnostic tool for land rover.I have autocom
cut pin 34 on black plug
Last edited by tango; 15th February, 2020 at 04:58 PM.
georgedigital (15th February, 2020), klonone (18th January, 2023)
Bookmarks