VW JETTA '11 MED17.5.6 swap

[dd1]

dd1
hi collegue help you

Safe clone ori ecu data to new ecu no problem and and i make you one immo off eeprom just in case

thnx for help

thank you but i am going to read the eep from the cluster and we go from there and see what happens

[dd1]

Yes by vvdi can done, but before dismount the dash to read the eeprom, save abs coding.

hi, i have removed the cluster, removed the back cover but could not find the eep. i have to remove the front cover. i am kind afraid to touch the needles. is it possible to do it with a vvdi2? via obd2? thank you

[pouleddy]

Hi, by avdi can done by boot, without disconnect the needles. or by other tools haz boot function.

[dd1]

Hi, by avdi can done by boot, without disconnect the needles. or by other tools haz boot function.

can this tool do it? i think i saw an option for it, it says SERVICE MODE

[dd1]

your dash 5C6 920 950 D with memory eeprom 24c64 & some dashes has 24c32, there is mcu also, but you must read eeprom to put it in service mode after by obd2 you can continue...

finally managed to read the cluster eep 24c64, cluster

[pouleddy]

can this tool do it? i think i saw an option for it, it says SERVICE MODE

Friend vvdi2 don’t have boot system, service mode in vvdi2 it mean you must read eeprom = must dismount the dash at all to arrive to eeprom.

[dd1]

i just did, took out the eep and read it. posted here

[dd1]

can you guys help me to finish this car up?????? thank you in advance

[pouleddy]

finally managed to read the cluster eep 24c64, cluster

hi, here the dump in service mode and the manual of photo how continue...

[dd1]

thank you, so on the eep i write the service mode file and solder it back to the cluster, install and then write the original, before servic mode, write it back?

[pouleddy]

after when you write service mode dump in eeprom, connect dash to car and write original eeprom data back to dash by obd2. and there you must check if the dash see your keys or not.

[dd1]

after when you write service mode dump in eeprom, connect dash to car and write original eeprom data back to dash by obd2. and there you must check if the dash see your keys or not.

thank you, i do not know what happened, now the cluster only has abs and traction light on, no display, no other lights light up. i tool the eep out and tried to read, it wont. somehow it got damaged. looking for another eep.

[dd1]

after when you write service mode dump in eeprom, connect dash to car and write original eeprom data back to dash by obd2. and there you must check if the dash see your keys or not.

hello, so i got another eep and wrote the dump, service mode. hooked up the cluster back, via obd2 wrote the original eep back. this was the screenshot before i wrote the ORIGINAL dump back, obd2. i had the turned off the key, tried to make a key, turned on the ignition and again went back to my original issue, WAIT 10 minutes and nothing happened

[dd1]

after when you write service mode dump in eeprom, connect dash to car and write original eeprom data back to dash by obd2. and there you must check if the dash see your keys or not.

hello everyone, so i finally got the car running, with an help of the DK member, now only thing is that the cluster shows 2-4 and can not get the miles to show up, it flashes and then the 2-4 comes up. any idea how can i get this taken care of????

[dd1]

taken care of, thank you again