Correct pinout for China Iprog reflash?
https://postimg.cc/LJdWWXww
Correct pinout for China Iprog reflash?
https://postimg.cc/LJdWWXww
Last edited by linas8; 21st January, 2023 at 07:25 PM.
fuzz1 (13th March, 2023), rtbdiagnostic (24th January, 2023)
Hi i'm new to the forum
i'm looking for solution to the error my iprog.
having log like this:
Test run
--- Test VCC = 3V ---
ADC0 (terminal 41) = 0.0 V. FAULT.
--- Test VCC = 5V ---
ADC0 (terminal 41) = 0.0 V. FAULT.
--- Test 10/12V ---
Uout = 10V
ADC2 (terminal 43) = 0.0 V. FAULT.
ADC3 (terminal 44) = 0.0 V. FAULT.
Uout = 12V
ADC2 (terminal 43) = 0.0 V. FAULT.
ADC3 (terminal 44) = 0.0 V. FAULT.
--- External power test ---
FAULT - EXTERNAL POWER IS NOT CONNECTED.
--- Pin test ---
PORTD.1 (Pin 6): FAULT
PORTE.0 (pin 7): FAULT
PORTE.1 (Pin 8): FAULT
PORTE.2 (pin 9): FAULT
PORTE.3 (pin 10): FAULT
PORTE.4 (pin 23): FAULT
PORTE.5 (pin 24): FAULT
PORTE.6 (pin 25): FAULT
PORTE.7 (Pin 27): FAULT
PORTD.6 (pin 5): FAULT
PORTA.0 (pin 20): FAULT
PORTA.1 (pin 21): FAULT
PORTA.2 (pin 22): FAULT
PORTB.0 (pin 19): FAULT.
PORTB.3 (pin 18): FAULT.
PORTA.5 (pin 2): FAULT.
PORTA.6 (pin 17): FAULT
PORTA.7 (Pin 1): FAULT
PORTB.4 (Pin 16): FAULT
PORTB.6 (Pin 4): FAULT
PORTB.5 (pin 3): FAULT
------------------------------
Test completed. Errors: 28
chinese iprog.
Someone help ?
Hi
Did you connect an external power supply?
Nothing seems to work on yours.
Post photos of your boards
333406344_1264467181117482_3062403797491374464_n.jpg333549601_1889438484737268_7551862026974431302_n.jpgIMG_0655.jpg
Moje deski.wydaje się, że brakuje im czegoś, czego
nie podłączyłem do zewnętrznego zasilania
Last edited by mil912; 14th March, 2023 at 09:56 PM.
Hi try to remove the diode i circled and check again Attachment 948766
Also check the lm317 to see if they are good.
Last edited by fuzz1; 14th March, 2023 at 01:47 AM.
335601321_5701496156644974_5600470177411250932_n.jpg
Sorry this is my power board.I didn't upload that photo
diode removed d3
what voltages must the lm317 have?
one lm317 is missing
Last edited by mil912; 14th March, 2023 at 10:01 PM.
Bookmarks