Fiat Doblo 1.9 MultiJet DPF and EGR Off

[atomantmk]

I need DPF and EGR Off for Fiat Doblo with:

ECU: EDC16C39
HW: 0281012853
SW: 1037379905

Thanks in advance

[momogsm]

HI

DPF OFF, EGR OFF, CHECKSUM CORRECTED

PASS IN PM

REPORT BACK

THANKS

[atomantmk]

Engine don't start, it could be checksum problem because I have old file with only DPF Off and engine start.

[momogsm]

Engine don't start, it could be checksum problem because I have old file with only DPF Off and engine start.

HI

NORMALLY THE CHECKSUM IS CORRECTED, BESIDES YOUR TOOL SHOULD CORRECT IT WITHOUT PROBLEM IF IT INCORRECTLY.

WAIT A MOMENT I WILL CHECK AND REPORT BACK

WBR

[flag]

no mate, you can't do full dpf egr off if not read by bdm

[atomantmk]

Now it's done, engine has started and we have found what the problem was.
Thanks for the time momogsm

Sent from my SNE-LX1 using Tapatalk

[flag]

no mate you have not solved that problem because you can't do full dpf and dtc off if not read bdm. if you will have any sensor for dpf, engine light will come again

[damjantuze]

I have that problem with fiat bravo over obd read dpf off and after 1 day light comes on dpf filter but when u connect to diagnostic show no dtc... need bdm read to make dpf off with no limp mode ???

[Junkyard Dog]

I think.Obd is partial read for this operation.

[flag]

hahahah sure, this ecu is very problem if not read bdm, obd is partial read. i did at least 70 ecu like this

[atomantmk]

DPF was done long time ago and i didn't saw check engine light or some other problems.

[AVDigitale]

OBD read enough for DPF or EGR off ,no need BDM