Just lift all the clips around the box, and try to pull it into 2 parts. It is easy to do with a screwdriver.
Hello all I have here a Ford Focus 1.6 tdci year 2013 that I need to replace the bcm on I have a used unit and copy all data across using forscan but it has not transferred the immo data. I have vvdi prog so was gonna use these connections:
Question really how to open this bcm must the plastic rivets be drilled in the corners? I can see and feel there are clips all round the side.
Thanks
IMG_9225.jpg
Just lift all the clips around the box, and try to pull it into 2 parts. It is easy to do with a screwdriver.
Galee (26th February, 2020)
Hi thanks I got it apart and connected vvdi prog to read the data but I get this error any ideas?
Check your soldering. Do you have a pic of the soldering you did?
Sent from my iPhone using Tapatalk
Flux is your friend as well as solder.
Sent from my iPhone using Tapatalk
Yes mate I redone it it had conformal coating so had contaminated the solder a bit.
PocketHero (25th March, 2020)
What files do i need to save to replace my dead bcm with a used one? i have the same errors and soldering is all good. need to set sizes manually does anyone have the info? also do fuses need to be in to read?
Last edited by misterwasp77; 22nd September, 2021 at 07:31 PM.
Anyone help with sizes?
I havent erased anything.
I have eeprom as 0
D flash as 32kb
P flash is 1mb
Pof is 64kb.
Is that correct
Last edited by misterwasp77; 23rd September, 2021 at 07:19 PM.
Bookmarks