Hello everyone!

I am working on a project for Polo 1.6 2005.
Already did ID and ready ECU file from Bosch ME7.5.10

HW: 0261208736
SW: 1037372804
VIN nr.:
SW ver.:
Spare:
Engine: ME7.5.10
HW Ver.:
SW upg.: 032906032L 2802
Installation:


When I load the driver for original file I receive this warning on Ecm Titaiumn:

WARNING: After using the eprom emulator it MUST read the 8 pin serial eeprom of key code for do not lock the ecu.
The programmation is possible only with KESS
Remember that if you don't execute this operation you can damage the Ecu for ever.
I am using Kess for reading and writing.
Can someone explain this warning please? Didn't see it before, now I am a litle afraid of writing modified file with Kess.

Thanks in advance!