ABS module renault clio 4 2016

[Jacopo89]

Hi to all, please someone can help me wit in circuit connection to read the 95640 eeprom of my abs? the enigma scheme does not work because my abs is a little bit different (there is not the same point of connection), i attached the pictures, pleas my car is stop now! thanks a lot to all!!!!
p.s. is the eprom in the other side of the board? s it difficult to arrive to it?
abs bosch.jpg

[drpeter]

Hi to all, please someone can help me wit in circuit connection to read the 95640 eeprom of my abs? the enigma scheme does not work because my abs is a little bit different (there is not the same point of connection), i attached the pictures, pleas my car is stop now! thanks a lot to all!!!!
p.s. is the eprom in the other side of the board? s it difficult to arrive to it?
abs bosch.jpg

read/write as 95128 and with 4,35 Volt!

[Jacopo89]

tnk you, but where is the connection pint on the oard to read it? i can use to read:
-upa
-xprog
-carprog
-digiprog.
-x-too

how can i set 4,35v? i tryed to read the epprom with a online scheme but the read is all FFFFFFFFF........

[Rito]

tnk you, but where is the connection pint on the oard to read it? i can use to read:
-upa
-xprog
-carprog
-digiprog.
-x-too

how can i set 4,35v? i tryed to read the epprom with a online scheme but the read is all FFFFFFFFF........

Is Better remove eprom, But if not remove you have voltage seletion in UPA (conections)

[Jacopo89]

Is Better remove eprom, But if not remove you have voltage seletion in UPA (conections)

ok, what are the connection point ?

[drpeter]

tnk you, but where is the connection pint on the oard to read it? i can use to read:
-upa
-xprog
-carprog
-digiprog.
-x-too

how can i set 4,35v? i tryed to read the epprom with a online scheme but the read is all FFFFFFFFF........

You read fffff because read/write voltage is too low.

[Jacopo89]

i tryed t read5v

[Jacopo89]

still error connection 2 ad and connecion 7 bad, someone have pinout (not enigma pinout)
?

[drpeter]

still error connection 2 ad and connecion 7 bad, someone have pinout (not enigma pinout)
?

I made one today no problem, same connections as your solder points.

[Jacopo89]

Please can you insert the connection point in image i have posted ? Thanks, i’ll use upa

[jomberykaso]

still error connection 2 ad and connecion 7 bad, someone have pinout (not enigma pinout)
?

.......................
abs renault 95128.jpg

[Jacopo89]

Thank you i’ll try lather end report, the Yellow is 6? I haveN’t to Connect 8 pin?

[jomberykaso]

DUSTER 2018 ABS PINOUT.jpg

.............................

[Jacopo89]

Thank you, i’ll try , the image is not definited

[jomberykaso]

picture is not mine, I'm trying to help you only