Reply With QuoteWhat ecu you wanna read? Protocol? Power supply?
Need more informations to help
Results 1 to 5 of 5
Thread: K-TAG Clon Problem Connexion
-
26th March, 2020, 07:11 PM #1Junior Member
- Join Date
- Oct 2019
- Posts
- 25
- Thanks
- 16
- Thanks
- 1
- Thanked in
- 1 Post
K-TAG Clon Problem Connexion
greetings to you all.
Is there a solution to this problem ?
389373869.jpg
-
26th March, 2020, 08:12 PM #2Newbie
- Join Date
- Mar 2012
- Posts
- 6
- Thanks
- 1
- Thanks
- 2
- Thanked in
- 2 Posts
-
26th March, 2020, 08:17 PM #3Junior Member
- Join Date
- Oct 2019
- Posts
- 25
- Thanks
- 16
- Thanks
- 1
- Thanked in
- 1 Post
tnx
Originally Posted by stephane76700
loss of communication between the Ktag and the BOSCH EDC16C34 ECUs BDM MPC mode, Using:
Positioning frame 14P800ADBO
Adapter 14AM00T01M
Ribbon cable 144300T100
-
31st March, 2020, 06:32 PM #4Top Poster
- Join Date
- Jan 2016
- Posts
- 185
- Thanks
- 64
- Thanks
- 43
- Thanked in
- 36 Posts
Hello
I had a problem with 16cp34 I was asked to connect a 12v power supply and the mass for the connector helped. Also check the connection in the connector ktag <=> ecu in my clone have added two connectors 144300t100 one was damaged
-
29th April, 2020, 10:33 AM #5Junior Member
- Join Date
- Nov 2015
- Posts
- 31
- Thanks
- 42
- Thanks
- 0
- Thanked in
- 0 Posts
Check wiring , some times broken cables.
Next step, try diagnosis ecu on bench.
If diagnosis ok and wiring ktag ok, then ....bad clone tool (at least for this ecu)
Bookmarks