None of the otherwise so capable members who have made immo off on Mercedes Edc15c6 CR2.XX ?
Hi valued members
immo off and 120 ohm problems :
I have an ECU on my bench for immo off with emulator
MB Sprinter W903
2.7 CDI
Automatic transmission
EDC15C6 CR2.xx
I'm using clone Julie immo emulator incl 120 ohm resistor on board, for CAN cars.
Have desolder the eeprom 5P08C3, and read /write as eeprom 95P08 (I have genuine uupa-s programmer and genuine vlada@2019v3 adapter)
Then I have changed the value in HEX editor :
01D0 to 01D4 = 02 02 00 ff ff...
So far so good...
In the Julie manual it says:
" if you are installing the emulator in a car with automatic transmission, solder 120 ohm jumper on emulator and
insert a 120ohm resistor between Can lines "
I can't find where to solder, or insert the 120 ohm resistor between the CAN lines!
There's same on China SQU 80...
Someone done this? I can't test it in the car now..
Looking forward to any answer
learning by doing, learning by experience... please thx is I helped you
None of the otherwise so capable members who have made immo off on Mercedes Edc15c6 CR2.XX ?
learning by doing, learning by experience... please thx is I helped you
Here better is to install specific emulator....wth julie you will have problems in these ecu
this ecu works good with all emulators, including china clones, 120ohm is in the board, just need to solder jumper, but I hear that for the first time, i have over 150 sprinters with CR2 emulator wich I build myself and without can resistor
...you can try on bench if it working put emulator and power ECU, plug1 pins 7,8 and plug 2 pin13 are +12V, plug1 pins 4 or 5 or 6 ground, if working on bench but not in car then try to solder 120R CAN jumper
here is jumper in red, pic is from OF68 manual
120R.JPG
Last edited by Shmortz; 28th March, 2020 at 12:12 PM.
Willinickersen (29th March, 2020)
it is electronic ignition or normal key?
if its with normal ignition no need of none resistor ,the car will start without....only modif dump ,solder julie and will work,i have done 10 of this by now...manual and automatic....if the car crank the engine must start,if it crank and not start ,another problem then someone else...
Willinickersen (1st April, 2020)
I`m using SQU 80 or Julie clone emulator . Both have 120 ohm resistor soldering in their manual for this car. With automatic transmission and without electric start.........
There should be another 120 ohm resistor between the cutted wires on the WSP . This was the answer to my question !
Solved
learning by doing, learning by experience... please thx is I helped you
Bookmarks