You must do adaptation g-sensor I think ...
I welcome everyone to this forum. Iprog read the block. I saw later that with an error. I got a problem with an error of 3000. Plus, I see that it’s not possible to clean the dump correctly. If there is a similar dump to mine. Put it here or by mail please. I have downloaded more than one dump from this block. After The block is identified, but there is no registration of the wincode and the name of the block. As I prescribe its native, everything is determined. lights up all abs tidy steering wheel all .thanks
You must do adaptation g-sensor I think ...
You use srs units files at your own risk. I am not responsible for any damages. Don't ask about passes, one file=one pass.
If I helped, please, use magic buttons reputation+thanks.
Best regards.
Dragon
does not give
yes check abs for acceleration sensor calibration
“There's nothing more dangerous than someone who wants to make the world a better place.” ― Banksy
in the block abs does not
I begin to calibrate in the abs block, and the program stops the calibration of the sensor. if the pillow block will be working without error 3000. then everything will be ok
Hello to all. Here you go Viiktor 2016 mazda 6. Hope this helps.
IF I HELPED YOU PRESS THE " T " BUTTON
joejam (9th April, 2020)
The firmware does not produce anything. I will alter all the flash. I’ll write about the finished work later
read the full
in the block you need the original flash. playing with other files is a waste of time. maybe someone hid somewhere full files. this can save the situation. a rare configuration block. I don’t even know where to look. thanks
you check this file
my friend, the trouble is that the file is incorrectly read from address 0008A10 and bytes 08 are present. broken iprog makes such an error ....- maybe I'm wrong. right now i will try your file again. thanks
Few times i had same problem. Problem was on bad contact on CAN adapter. I solved problem with donor dumps. You should try different eeproms, don't need full.
Yes, I also processed these files
Same pass.
viiktor (31st March, 2020)
Bookmarks