Test this file and report.
Pass in PM.
hi im working with a cr140 engine i swapped. ecu number: 03l 906 019 hb cjaa 4817 hw:h15. engine is fitted with a hx30/35 holset turbo and the smart actuator and maf being deleted is putting it in limp mode. it is throwing a lot of codes. if anyone could help me out i would greatly appreciate it.
heres a list of codes its throwing:
p0045
p0101 mass air
p0405 egr
p0486 egr
p048e
p0627
p2017 intake flap
p2100 throttle actuator
p2101 throttle actuator
p242a
p246e
p2564 turbo boost control sensor
p2632
Last edited by BigTurboAlh; 3rd April, 2020 at 04:08 AM.
Test this file and report.
Pass in PM.
BigTurboAlh (3rd April, 2020)
I’m running a big t3 single turbo. P2564 gotta be deleted
I will test at lunch time thanks
It’s a wastegated turbo. Not a vgt turbo. There’s nothing to repair.
Last edited by BigTurboAlh; 3rd April, 2020 at 04:33 PM.
There is no repair it needs deleted
I tried the file and still in limp mode
BigTurboAlh (6th April, 2020), ECU KING (5th April, 2020)
contact me i can help you with this
Proffesional ECU & TCU Tuning
Petrol and Diesel Engines
File Service
BigTurboAlh (4th April, 2020)
and a tested solution?
Hi,
Do not waist Your time... This type of ECU expects data from the MAF sensor in order to figure out Air Quantity. Without it there is no way to run properly.
Also You can not use any force induction system that will push more air in than the measuring capacity of the specific MAF.
The only way to do this right is to use an aftermarket fully programmable ECU.
Best Regards
@naskochipa wouldn’t start with that file flashed back to stock and it starts
Bookmarks