why do you need write mcu?
immo stored in eeprom
Hello everyone,
Please have anyone experience with read/write the IAW5NF.T1 ecu by BDM. I have an ECU from fiat Stilo 1.6 2003 and inside ecu is MCU Motorola MC68F375 (8J28H). I have change the MCU with a new one and now i can not write the software by K-line. Because the ecu didn't communicate with K-line when the MCU is blank.
So any help how can i write this mcu by BDM and which devices can do this job ?
why do you need write mcu?
immo stored in eeprom
need help
now my goal is to buy xp-005
who will help?
I need to write because MCU is blank is new from UTSOURCE so it's needed to write the software
Any help ?
How can do Xprog that ? Which MCU is needed to select on Xprog for read and writing MCU ? Because MC68F375 is not included in Xprog databases
you can write flash with pinout in connectors of ecu with kess for example.
If i Helped you,use thanks and rep button to thank me back
Meat-Head (15th April, 2020)
IAW5NF BDM port
BDM.jpg
Thank You for this but do not understand the RED line in the second pic.
Can You please redraw...
Best Regards
Knowledge is to share... so if I have helped just press [Thank You + Rep.]...
Stelaras26 (31st October, 2022)
Thank you all of you mate for helping on this topic. Have any one idea with which tools can write this MCU from BDM pins ?????
Last edited by evisdaci; 18th April, 2020 at 10:42 PM.
Nobody have any new information about this topic ????
Last edited by evisdaci; 21st April, 2020 at 08:48 PM.
all you need is programmers that support this mcu,so google it mate.
If i Helped you,use thanks and rep button to thank me back
Bookmarks