metaleks (27th December, 2021)
metaleks (27th December, 2021)
Thank you Fantomel !!!
Great job ...
bar7212345 (25th October, 2021), Gurbettekises (7th February, 2022), jgdf (3rd September, 2023), npocmaka (1st May, 2021), torzet (21st December, 2021), volodin69 (20th July, 2021)
2.jpg1.jpgOp-com.jpgx.jpgxx.jpg
Cześć,
Przyjaciele, mam op-com jak poniżej ze zdjęć.
Chciałem zapytać, czy mam odpowiednie urządzenie do konwersji.
W tej chwili działa u mnie program VAUX-COM_120309a + 160115a
Obsługuje samochody do 2016 roku.
Czy mogę skorzystać z przewodnika przyjaciela Fantomela? Jak ktoś może mnie dokładnie pokierować, jak to zrobić?
Pozdrowienia
jgdf (3rd September, 2023)
Your interface looks like a good Opcom V5. Read "how to use". Install Fantomel software and enjoy.
I installed the software: OP-COM_200603a_EN_Pro_v20830_Free4All
The interface itself has updated to version V01.67
But the problem is that it is not related to the car.
Do I have to do anything after installing the Fantomel program? Any exact instruction? I will be grateful.
USB FTDI 2.8.30.0 drivers are correct?
Thank you very much in advance for your help. greetings
interfejs.jpgsterowniki.jpg
jgdf (3rd September, 2023)
Thank you Fantomel !!!
Thank you Fantomel!
I was able to get the v5 adapter from Ali Express and it updated fine. The only issue is that when programming it gives a "this function is not available" error.
I have tried all the attached versions on windows 7 64bit. It identifies my zafira-b 2013 but no luck trying to enable cruise control.
Thank you for the information. I redone my OPCOM NEW, CH-CAN works ,except version 2006003.
Thank you Fantomel !!!
Hello everyone!
Is this a good one?
IMG_20210528_200725.jpg dasdas.jpg
Last edited by sopido; 28th May, 2021 at 07:35 PM.
thank you very much for your work
Thanks for your sharing
@sopido Fake pic chip.
If you like my post and it helped you please press THANKS.
Thank you Fantomel !!!
Great job ...
Bookmarks