post eprom from cas 4kb, not flash
post eprom from cas 4kb, not flash
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
systemlinux (26th May, 2020)
Copy EEPROM to both CAS3 and the vehicle does not recognize the remote.
With the old CAS the vehicle is dead and with the new CAS the lights are centralized, but it is immobilized.
so I think there must be VIN and ISN in the flash too
just post old and new eeprom files like requested...
systemlinux (26th May, 2020)
not work if witing only eep becouse both probably have diffrent sw isn is in eep how writing boys
or you have hw diffrent quartz one metal - old and one brown -new
systemlinux (26th May, 2020)
How about posting all files from each unit? Folks would have a better idea of what's going on.
<---- Coin of the Realm.
systemlinux (26th May, 2020)
a thousand apologies for the delay.
I upload backup of each CAS
read isn from ecu
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
systemlinux (26th May, 2020)
I dont no what car you have, how you think that i can help you in this moment, post picture from ecu or full bdm
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
Attached backup ECU BOSCH 0 261 S04 115 made with KTAG
If you ever decide what you want to do inform...eep is not enough to start car. You must transfer flash also. Vin isn and all data are in eeprom.
Professional BMW immo solutions
Macedonia is one and GREEK!!!
XPROG detected bad sectors on the CAS3_OLD flash and does not let the flash copy to the CAS3_NEW.
The idea is to transfer the necessary info to the new flash, in order to copy it without problems.
erase mcu flash with xprog , and then write new flash.
Professional bmw key service cas 3/3+ 4/4+ repair = reset ews egs 8hp = 6hp-egs19d
I understand that there is a BMW editor or explorer software, which serves to synchronize DME with CAS3.
Bookmarks