Sirius32 with CAN

[ziko]

Hi,I made many sirius32 without CAN , but this one is with CAN , I put emmu, on desk says immo deactivated but when connect on car engine not start (in manual emmu write need remove immo lines from UCH, are they mean CAN lines???)
I see on forum someone has sw off solution got sirius34 CAN, so maybe sirius32 CAN can be too off sw

Tnx

[rafal]

only emu.....................no others way my friend
2nd answer - yes CAN NETWORK lines must be cutted

[ziko]

CAN from ecu or uch?
How will communicate uch after cutting can.
I have also manual if car not start to put relay to remove CAN wires from network on ecu then ignition on to tead emmu and then realise relay to be Can again connected in system

[rafal]

you need cut can lines from UCH
you will have - 2 lines IN to uch and 2 lines OUT - cut and connect together - 2x H + H and 2x L + L
CAN H + CAN L - in
CAN H + CAN L - out
together H + H
together L + L