Ktag not working in bdm

[Slav1984]

Hi I got ktag clone and is not working in bdm I tried 4 different ecus and few different chargers and always getting hardware configuration not supported . I done few ecus in boot mode edc17 and that’s works perfect but not in bdm even don’t recognise ecu . I tried edc16c9 Iveco , edc16c39 from Saab and Zafira and Med9.1 from vag . I use bdm frame and direct connection . Will anybody know any solution or suggestions? Thanks in advance

[galiza]

It usually works well. Maybe bad clone (need rework) maybe wrong connection. Can you post pictures about connection on EDC16C39?

[Slav1984]

It usually works well. Maybe bad clone (need rework) maybe wrong connection. Can you post pictures about connection on EDC16C39?

IMG_3956.jpg
IMG_3955.jpg
With bdm frame and without using cable what ktag said . No problem with connector on boot mode with edc17cp14 done few


Sent from my iPhone using Tapatalk

[figani]

IMG_3956.jpg
IMG_3955.jpg
With bdm frame and without using cable what ktag said . No problem with connector on boot mode with edc17cp14 done few


Sent from my iPhone using Tapatalk

just take a look at your photos...
on one photo and on other photo...
you hold the bdm cable around 180 degrees...

12V and ground are going through this lines...
if you really had contact with pads on pcb...
then dead, asta la vista, good night, tod, and so on....

[Slav1984]

Picture taken just to show was connected when was reading with ktag manual


Sent from my iPhone using Tapatalk

[Panathaole]

Post a clear photo of adapter, to see if you use the correct one...

[galiza]

just take a look at your photos...
on one photo and on other photo...
you hold the bdm cable around 180 degrees...

12V and ground are going through this lines...
if you really had contact with pads on pcb...
then dead, asta la vista, good night, tod, and so on....

Yes, I think so, the BDM adapter is turned 180º (at least It doesn´t match with gallo´s manual) so......

[Slav1984]

Yes, I think so, the BDM adapter is turned 180º (at least It doesn´t match with gallo´s manual) so......

I just put that quickly for picture when I connect I always have wright way like ktag say . I send it to get exchange was faulty unit


Sent from my iPhone using Tapatalk

[djsy2004]

i had same issue and turned out to be ac adapter it is 12v 2a soon as i used a 14v 2a adapter worked fine

[Slav1984]

i had same issue and turned out to be ac adapter it is 12v 2a soon as i used a 14v 2a adapter worked fine

I tried that I use now 12v 4a and still not working I send it to get exchange for new 1 hopefully will work when then replace it


Sent from my iPhone using Tapatalk

[Slav1984]

ProbleM solved ktag got replaced all working fine


Sent from my iPhone using Tapatalk