It usually works well. Maybe bad clone (need rework) maybe wrong connection. Can you post pictures about connection on EDC16C39?
Hi I got ktag clone and is not working in bdm I tried 4 different ecus and few different chargers and always getting hardware configuration not supported . I done few ecus in boot mode edc17 and that’s works perfect but not in bdm even don’t recognise ecu . I tried edc16c9 Iveco , edc16c39 from Saab and Zafira and Med9.1 from vag . I use bdm frame and direct connection . Will anybody know any solution or suggestions? Thanks in advance
It usually works well. Maybe bad clone (need rework) maybe wrong connection. Can you post pictures about connection on EDC16C39?
It is better to arrive 10 minutes early, than to be bored all the way.
IMG_3956.jpg
IMG_3955.jpg
With bdm frame and without using cable what ktag said . No problem with connector on boot mode with edc17cp14 done few
Sent from my iPhone using Tapatalk
Picture taken just to show was connected when was reading with ktag manual
Sent from my iPhone using Tapatalk
Post a clear photo of adapter, to see if you use the correct one...
i had same issue and turned out to be ac adapter it is 12v 2a soon as i used a 14v 2a adapter worked fine
ProbleM solved ktag got replaced all working fine
Sent from my iPhone using Tapatalk
Bookmarks