Photos from module
Hi mates. Need some help.
Got the car to alternator repair. After battery dissconnection i have DEF048 fault with immo data wrong from EPS.
So now i need to make it virgin and code with clip.
EPS unit number: 8200937950B
Eprom is located under plate and i know there is solution to read and make it virgin in-circuit, But I can't find this points.
Can someone help me with this?
I have VVDI prog and there is scheme to connection to processor and option - erase, but as i found here - immo and vin are in eprom, not in proc.
Last edited by VitalyR133; 3rd August, 2020 at 11:11 AM.
Photos from module
Last edited by VitalyR133; 3rd August, 2020 at 11:13 AM.
hello,,in some cases renolink or ddt4all..makes eps virgin through obd ...the codification is maked by the car itself,first virgin the steering and then put the ignition on APC+ some time ,then cut the ignition few seconds and another time ignition APC+...after this procedure make a diagnostic with clip,erase faults and check the state of inmobilizer on injection and uch ..
this procedure works on fluence and megane 3 with eps steering and card key ..i think is the same on clio 3 ..
VitalyR133 (3rd August, 2020)
I have installed ddt4all but didn't managed to connect with eps. Just lack of time. I will try it tomorrow morning and hope it will be ok.
As I see at another site there is a possibility to write Vin and crc check. But nothing about virgin.
Отправлено с моего SM-N975F через Tapatalk
Confirm, DDT4all make this EPS virgin through OBD. Done in 5 minutes xD
Bookmarks