file virgin
pass pm
please report
Hi
The customer's computer is burnt out due to short circuit ( his own fault )
,he buy a second-hand computer, I made it Virgin, car started but run not good ( max 4000 rpm ),,
I tried to learn throttle body again, everything has been reset with Delphi ( Calibrate rpm sensor + Reset adaptation values + Reset vehicle configuration + Learning throttle adaptation ) , after that I wanted to make proxy settings, but comminication with BSI is not posible !
any advice ? can someone make it virgin again , maybe my virgin file were not ok !
thanks
file virgin
pass pm
please report
mrchip (6th August, 2020)
#phonic wheel
Was Banned For Being Certifiably Insane and Stupid
mrchip (6th August, 2020)
please tell me more about that,, you are right, I get every time that DTC code P1300-55 Phonic wheel learn
I cant make proxy allingment ( cant communication with BSI ),, how to fix Phonic wheel,, after I did reset ( with Delphi ( Calibrate rpm sensor + Reset adaptation values + Reset vehicle configuration + Learning throttle adaptation ) car wont crank,, I hear relay clic in fuse box ( engine side ), I did bypass starter motor relay,engine crank well but not start
thanks
Last edited by mrchip; 6th August, 2020 at 09:42 PM.
Hi dear Pinotec , your file is OK ! key is self learned after first ignition on , but I cant still get communication with BSI, I think car has more another wiring or module's probleem
if you want try immo off for start car , but no resolve the problem on bsi..
used ecu is equal at ecu broken ?
mrchip (7th August, 2020)
same password, disconnect antenna
please report
regards
mrchip (7th August, 2020)
Phonic wheel get engine warm, hit rev limiter 2 seconds, do this 3 times wait few seconds turn off
Something to do with cam algnment
source:- some bloke with cancer
not sure on your problem but try whatever fresh file you have
turn ignition on for few minutes, make a cup of coffee THEN try starting
as ecu is learning if auto (no clutch switch) or manwel (clutch switch)
Was Banned For Being Certifiably Insane and Stupid
mrchip (7th August, 2020)
If dash, lights, central locking, windows work ok, then bsi is good, but your diag tool not. Try other, eg mes and see if you can communicate with bsi.
I agree with Meat-Head - phonic wheel.
Dear Pinotec, I wrote your Off file, tried first without key, immo light on , car wont start,,then connected antenna --> immo light off, key code learned --> car dont crank
maybe I did it wrong , not waited, started too quickly
problem is RPM not higher than 4000 , it must 5000-6000 for cam alligment, maybe I did it wrong, after writing Pinotec his file I started the car too quickly, nex time i will take time for an make up or coffee
I cant get communication with BSI, tried with Fvdi, multiscan, elm327, delphi, today tried other BSI, same result, no communication for proxy alligment,, ( i can get communication with other module's on canbus line )
thanks to all, to be continued
Hang on
rumor states the poxy alignment is for bsi, instrumental, radio (not sure air bag)
OFF TOPIC:-
a ducato van is nothing more than an over fed punto you do srs poxy alignments in bsi
Was Banned For Being Certifiably Insane and Stupid
Bookmarks