Did you make the battery off for a reset? My last 2 Astras H inhad to do it.
Hello!
Programmed a aftermarket remote key (from 3DGroup) today to a Opel Astra H 2005 in a AKL senario. AVDI put the new transponder in key memory place 3 and remote working fine. But car will not start. The yellow immo lamp is blinking. I get a fault code on wrong transponder signal.
Any ideas are welcome!
Did you make the battery off for a reset? My last 2 Astras H inhad to do it.
Last edited by Alpaholic; 14th September, 2020 at 02:10 PM.
mjoesen (17th September, 2020)
Reset takes 5sec. Can bad key in this case
mjoesen (17th September, 2020)
Key read fine. Could it be a bad ignition coil if I manage to get the transponder in to key memory?
if ignition coil is bad you could not program key in first place.... probably bad key....
mjoesen (17th September, 2020)
bad key or faulty CIM, quite common
Tools owned -
AD100 PRO, Lonsdor, FVDI 18, FVDI 20, VVDI PROG, VVDI2, VVDI MB
CGDI BMW, SuperVag, Renault ECU tool, OBDstar X300 DP Plus, AUTEL im508
VVDI Mini Keytool, KeyDIY KDX2, SBB, ACDP CAS/KVM
Opcom, VCDS pro, Diagbox, Multiecuscan, Forscan, JLR SDD
mjoesen (17th September, 2020)
Bookmarks