I am lost in view of the number of maps corrected for a stage 1 ....
So I found 12 maps changed to be optimized.
thank you for your information I continue to look for the% because I have no information on the number to change.
thank you again friend !
Last edited by AperoMyke; 27th September, 2020 at 10:11 AM.
Antastra1989 (20th September, 2020)
TUNING--FILE SERVICE--VMAX--EGR--DPF--FLAPS--LAMBDA--DTC--IMMO..........POSSIBILITIES ARE ENDLESS
SPECIALISE IN TUNING DIESEL ENGINES
(DEMON DEVELOPMENT)
IF I HELPED YOU DONT FORGET TO HIT THANKS AND REP POSSIBILITIES ARE ENDLESS
AperoMyke (20th September, 2020)
a first for me the insertion of map pack
if I understood correctly here is the photo
I still have found how to save it in .bin
TUNING--FILE SERVICE--VMAX--EGR--DPF--FLAPS--LAMBDA--DTC--IMMO..........POSSIBILITIES ARE ENDLESS
SPECIALISE IN TUNING DIESEL ENGINES
(DEMON DEVELOPMENT)
IF I HELPED YOU DONT FORGET TO HIT THANKS AND REP POSSIBILITIES ARE ENDLESS
AperoMyke (21st September, 2020)
Thank you
Last edited by AperoMyke; 22nd September, 2020 at 05:53 PM.
Last edited by AperoMyke; 22nd September, 2020 at 01:10 PM.
Here you go dyno tested stage 1 file use this or compare with your file this file is ok to write straight on
regards
pass in pm
Last edited by chrisimerk; 23rd September, 2020 at 03:42 PM.
TUNING--FILE SERVICE--VMAX--EGR--DPF--FLAPS--LAMBDA--DTC--IMMO..........POSSIBILITIES ARE ENDLESS
SPECIALISE IN TUNING DIESEL ENGINES
(DEMON DEVELOPMENT)
IF I HELPED YOU DONT FORGET TO HIT THANKS AND REP POSSIBILITIES ARE ENDLESS
I don't know how to thank you!
I test it tomorrow noon directly
and I'll get back to you
cordially, Myke
Small return
So with your carto: The car behaves like the original but with more cv. (lambda sensors behave normally)
With mine: Completely different car, big thrust in 3/4/5 / 6th but nothing in 1 / 2nd speed.
This is where I see that I am missing some settings to have something homogeneous to the original carto.
Thank you for your help and for showing me the different maps on my Astra!
Looking forward to read it again
Sincerely, Myke
Your map you are pushing too much boost more fuel hight torque curve if standard clutch won't last that long too much for standard car this is a safe map put the stage 3 if you want loads of gains but would not advise with standard car
Regards
TUNING--FILE SERVICE--VMAX--EGR--DPF--FLAPS--LAMBDA--DTC--IMMO..........POSSIBILITIES ARE ENDLESS
SPECIALISE IN TUNING DIESEL ENGINES
(DEMON DEVELOPMENT)
IF I HELPED YOU DONT FORGET TO HIT THANKS AND REP POSSIBILITIES ARE ENDLESS
Hi, no, that suits me perfectly with your mapping.
just the breaker has 8000 rpm
this is the card for re at 6400 rpm?
thank you
Myke
Last edited by AperoMyke; 27th September, 2020 at 08:11 AM.
Hi, how are you ?
So if I understood correctly, you just changed the injector stop time to 65535.
the breaker was still there
on your file the downtime at 6080 was longer. (42598)
Did I understand the principle correctly?
Thank you
Hi,
which brings me to
a cold engine breaker at 32,500 rpm
and at a temperature 90° of 6500 rpm
is that possible?
thank you
Last edited by AperoMyke; 28th September, 2020 at 06:46 AM.
Can someone look at my Stage 1 for my Astra H VXR?
3rd gear boosts very well and then hit limp mode in 4th
Toy'd with a few maps and haven't had a problem
PS, sorry for hijacking. Just thought this post has people with knowledge of 7.6.2
Eight bytes walk into a bar. The bartender asks, “Can I get you anything?”
“Yes,” reply the bytes. “Make us a double.”
Bookmarks