Lots of people are having issues with the following DTC (P010129 - MAF Sensor 1, invalid signal received) on the E-Class W212 Delphi CRD3.5 (type 2). Often it turns out to be a leak from air intake pipe hose or a very dirty air filter, sometimes even dpf-related. But if, for any reason, the fault code can't be cleared after following all the official procedures, then is it possible to make a "DTC-off" solution? I've attached ori ecu dump. Thanks in advance for your help.
Results 1 to 2 of 2
-
19th September, 2020, 10:19 PM #1Top Poster
- Join Date
- May 2020
- Posts
- 109
- Thanks
- 144
- Thanks
- 21
- Thanked in
- 11 Posts
DTC remove P010129 W212 MB E Class DELPHI CRD3.5 OM651 possible?
-
20th September, 2020, 07:52 PM #2DK Veteran
- Join Date
- Dec 2017
- Location
- Croatia
- Posts
- 967
- Thanks
- 30
- Thanks
- 608
- Thanked in
- 458 Posts
Best regards
2WD Dyno , Magpro2 X17, FLEX Master , KESS Master , AUTOTUNER Master, Byteshooter Master, EVC Winols Reseller
Official Magicmotorsport DistributorCode:FILESERVICE: Tuning / DPF / EGR / Adblue / DTC / Immo
Official Autotuner Distributor
Official Alientech Distributor
-
The Following User Says Thank You to jurebv For This Useful Post:
vdiag (21st September, 2020)
Reply With Quote
Bookmarks