Renault midlum 2007 akl

[iozo]

Hello ? I have problem whit this truck , it is in this situation from 2 years. Battery’s is dead on truck , owner have aimple key whit out transponder , so i remove immo box and read eeprom st95040 , make transponder whit vvdi2 on super chip and back to truck but it is not have starter , relays are clicking but not start . On dash have error for key. Write new pcf7936 transponder , write back generated dump and beck to truck , same . So i suspect it lost sync between immo ecu and vecu as what i read in form . So question is if i plug my can clip becaus it is 24 v will he die , and whit what i can make diagnostk . Is some one try vvdi2 on this trucks. I have original tango but but not sure do i need to buy maker for it if truck have other problems . Thanks in advice

[paulsta]

Hello ? I have problem whit this truck , it is in this situation from 2 years. Battery’s is dead on truck , owner have aimple key whit out transponder , so i remove immo box and read eeprom st95040 , make transponder whit vvdi2 on super chip and back to truck but it is not have starter , relays are clicking but not start . On dash have error for key. Write new pcf7936 transponder , write back generated dump and beck to truck , same . So i suspect it lost sync between immo ecu and vecu as what i read in form . So question is if i plug my can clip becaus it is 24 v will he die , and whit what i can make diagnostk . Is some one try vvdi2 on this trucks. I have original tango but but not sure do i need to buy maker for it if truck have other problems . Thanks in advice

Try superchip on position 2, i had this issue too

[paulsta]

Did it work?

[iozo]

Didn`t try custumer are want all to get fast and go to dealer

Did it work?