Reply With QuoteConnection: 1,2,4,5,6,8..................and use 3.0v for reading and writing.
Originally Posted by eddyann
Tried anything but still the eprom cannot be read. it said vdd/vcc out of range
tried
a) using the test clip
b) individually 8 pin miniature connector
c) 4,5,6,8 connection
d) J1 jumper
e) external 12V supply
do I need to take out or desolder the ST95640 and read it 'ouside' to make it work?
the error
https://ibb.co/LgxNqN5
the connection (tried 4,5,6,8 and also all 8 pins)
https://ibb.co/jyhqQZY
Results 1 to 3 of 3
-
24th September, 2020, 02:21 AM #1Newbie
- Join Date
- Jul 2020
- Posts
- 7
- Thanks
- 1
- Thanks
- 0
- Thanked in
- 0 Posts
UPA - USB v1.3 read error (ST95640)
Tried anything but still the eprom cannot be read. it said vdd/vcc out of range
tried
a) using the test clip
b) individually 8 pin miniature connector
c) 4,5,6,8 connection
d) J1 jumper
e) external 12V supply
do I need to take out or desolder the ST95640 and read it 'ouside' to make it work?
the error
https://ibb.co/LgxNqN5
the connection (tried 4,5,6,8 and also all 8 pins)
https://ibb.co/jyhqQZY
-
24th September, 2020, 05:07 PM #2V.I.P. Member
- Join Date
- Aug 2015
- Location
- 42 52 41 5A 49 4C
- Posts
- 1,891
- Thanks
- 481
- Thanks
- 2,093
- Thanked in
- 1,167 Posts
If I was useful to you, thank you by pressing the thank you button . 
-
26th September, 2020, 08:11 PM #3DK Veteran
- Join Date
- Jun 2020
- Location
- Brazil
- Posts
- 356
- Thanks
- 135
- Thanks
- 295
- Thanked in
- 205 Posts
When did the jumper change in the program too?
Bookmarks