Importer Number 0? Give a number there, for example 5
Importer Number 0? Give a number there, for example 5
You have the correct security code?
tried several values always gave error.
HI, You must calculate login code (see VCDS label file) , it depend by car construction.
You must calculate codding too. Login, set coding and steering angle sensor calibration must be done by one ignition switching on.
All needed info is in Ross-tech Wiki .
Reality of life :
1:Never argue with an idiot, he will pull you down to his level and overcome you with experience
2:Envy is the confession of inferiority
3:Everyone lies
---------------------------------------------------------------
How much trash you leave behind so much trash someone will have to read or maybe you yourself
If you like reading garbage, don't slow down, just speed it up
I also tried coding bosch 5.7 with vcds in audi a6 2002.. For The First time i've put login, coding and wsc and that's all. In next ignition cycle abs module lost coding again.
I did coding again and ALSO align g85.
After these steps abs module remember the coding...
Strange but real... i'm having these situations only with these abs 5.7 models.
Already in 5th post I said the whole procedure (login, coding and steering angle calibration) must be done in one ignition on cycle!
Car in Audi... Ok
Need to enter correct login code to make any changes. Once login is accepted you cant back out of controller,make changes, save. Then back out.
Bookmarks