hi...thx. cand u leave me pass?
Check your PM. regards
no work....anyone please?
Hi, test and report please. Flash it Particial
Make sure you bridge in 20 Pin connector (MS41 =! OBD) pin 18 for activation programming voltage...
Hi. Your file is too short...only 24kb
He tell you about he only sent partial...
Mates... First, "pro tuner" isnt able to do... other guy post partial section only because he mod in rr and dont want spent time to set in offset xD.
As you see ... threader beginner absolutly noob with clone kess ... did you think somebody who arent able to set pop and bullshit got knowledge about the offsets?
Heat up exhaust well... and dont forget about the thing I mentioned above with brideging connector wires.
And clear this ****** message box to get pw.
man, I've been working in the field for 5 years but I've never written a smaller sheet than the original. I also have original tools, such as flex, x17, AT, smok, icom etc
M.Jojo (8th November, 2022)
Can u leave me pass?
Are you kidding your message box is again full!
For the other copy cats... dont waste my time by messaging password password password! NON of you got it! Only Threaderstarter, everytime.
Than you should be able to transfer ...man, I've been working in the field for 5 years but I've never written a smaller sheet than the original. I also have original tools, such as flex, x17, AT, smok, icom etc
Last edited by Lambda1; 28th November, 2020 at 10:03 AM.
My imbox is clean
If I can say something... Lambda1 did very good work on my file, no rev hang, pops, cat delete , hardcut. Thank him again I could understand the ecu MS41 and how it works after couple attempts with modifying file by myself and making logs.
there is no problem to help others... but if you will sent password 3 times... and everytim pn box is full... its sucks so hard.
Bookmarks