Hello!
Audi A6 C5/2,5l V6 TDI/MY02
The injection pump control unit is broken and had to be replaced from an intact used car. We tried to change the pump, but we could not find the required PIN in the instructions. Can anyone help?
Instructions we received
Code:
Determining VIN & IMMO-ID
Engine Control Unit (ECU)
[Select]
[01 - Engine]
Look at the first "Extra" field. The first 17-digit string is the VIN. The second 14-digit string in the Immo-ID.
[Close Controller, Go Back - 06]
---OR---
[Select]
[01 - Engine]
[Meas. Blocks - 08]
Select Block 081.
[Go!]
The first 17-digit string is the VIN. The second 14-digit string in the Immo-ID..
[Done, Go Back]
[Close Controller, Go Back - 06]
Injection Pump Swapping
Prerequisites:
- The NEW Injection Pump is installed in the car.
- Battery voltage at least 12.5 V.
- Make sure to have the Immobilizer PIN, for the Engine Control Unit (ECU).
[Select]
[01 - Engine]
[Login - 11]
- 4-digit PIN
- The PIN needs to be entered as 5-digit number. For example, if your PIN is 1234, enter 01234.
[Do it!]
[Adaptation - 10]
Enter 050 in "Channel Number".
[Read]
- 4-digit PIN
- The PIN needs to be entered as 5-digit number. For example, if your PIN is 1234, enter 01234.
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
- Switch OFF the ignition and let the car sit for ~1 minute, then switch ON the ignition again.
- Start the Engine to verify the adaptation was successful
Motor ECU files are read AVDI (Abrites)
Bookmarks