exchange dashboard 4F0910930A audi A6C6 2006

**elektryk13a** · 19th January, 2021, 05:17 PM

Hi
dashboard 4F0910930A damaged fuel gauge or replacing it with a new one, it is enough to change the eeprom 95160

**rafal** · 19th January, 2021, 05:27 PM

https://www.digital-kaos.co.uk/forum...i-a6-dash-swap

**elektryk13a** · 19th January, 2021, 07:11 PM

IMG_20210119_182641.jpg IMG_20210119_182650.jpg

4F0910931A old
4F0910931F nev
iF I make a copy , I can come back

**brend** · 19th January, 2021, 07:23 PM

Swap eep away not work,tested just no!

Originally Posted by elektryk13a

Hi
dashboard 4F0910930A damaged fuel gauge or replacing it with a new one, it is enough to change the eeprom 95160

**elektryk13a** · 20th January, 2021, 09:02 AM

Eeprom 95160 + Mcu
Will it be OK

**elektryk13a** · 20th January, 2021, 09:44 AM

Does the charge 95160 affect the fuel indications because there are traces of soldering car bought with this defect.

**bendzji** · 20th January, 2021, 10:51 AM

problem with showing fuel level is usually located in the wiring harness in fuel tank , I think that soldering mcu+eeprom will do the job but I think you should make Component

**elektryk13a** · 20th January, 2021, 12:29 PM

The vcds clocks test fuel Goes
1/4 range

**elektryk13a** · 20th January, 2021, 01:17 PM

FotoIMG_20210120_131010.jpg69

**brend** · 20th January, 2021, 01:42 PM

Have you mcu bdm pinout for read/write?

Originally Posted by elektryk13a

Eeprom 95160 + Mcu
Will it be OK

**elektryk13a** · 20th January, 2021, 02:13 PM

Eeprom 91560
M29w160ET
64f2639f20
?

**elektryk13a** · 22nd January, 2021, 02:50 PM

All 3 solder over

**elektryk13a** · 23rd January, 2021, 09:48 AM

Pinout bdm. ???
I have kess ktag orange 5 carprog

**brend** · 23rd January, 2021, 02:54 PM

Kess no,because this tool work only protokol detect away.
orange 5 carprog.....both have mcu pinout image,so ......for you this must by easy without stupid question.

Originally Posted by elektryk13a

Pinout bdm. ???
I have kess ktag orange 5 carprog