what car?what engine?
Hi, i got an ebay opcom, installed drivers and it connects to the laptop, and the car.
The problem comes when trying to reset or program.
Installed a used ecm as the one in the car was fryed, reset with the pin, and got the correctly reset message, however tried to reset and program the rest of the gear and nothing works properly, so went back to the ecm and still holding the old pin and locked to others, so for some reason isnt resetting, also, when going in bcm any pin i enter will say its correct and will enable all the functions , but then not getting any sucesfull programming messages which actually program anything.
Any ideas of im doing something wrong?
Thanks
what car?what engine?
If i Helped you,use thanks and rep button to thank me back
Very strange. Maybe bad opcom. Make sure battery is fully charged or use retainer. Low voltage used to affect Corsa C when programming clocks ~♂️
V Series TMS470 / EEPROM data - encryption / decryption, totally pwned.
IEC 62056-21 - new discussion: sonsivri.to/forum/index.php?topic=60412.0
if you try to reset ecu on bench via other programmer?
same result?also for corda d,if you reset ecu,you have to reset and reprogram everything that has immo like bcm,immobilizer and dashboard too,or else car wont start
If i Helped you,use thanks and rep button to thank me back
I did all with other car running connected. Maybe too much voltage?
Yes, i tried to reset all, but it do not reset and reprogram anything. For example, if i go to program variant , i change the values and hit program, then it pops the message as programmed, go back to that menu and still the same
...After programming switch off ignition for 30 sec.
Probably bad opcom. When ecu is replaced don't need to reset anything else, just program ecu (has to be reseted), with car pin from bcm. Then program other config and vin and that's it.
Well, i have 4 opcoms from differnt providers, just in case, i will try them and report to see what happened
Bookmarks