After bypassing the gateway with a FCA 12+8, i can erase dtcs.
However the dtcs, caused by the missing gateway remain after reconnecting the gateway.
I use launch easydiag.
If i would tapp in to the network, beyond the gateway.
https://www.americankeysupply.com/pa...curity-gateway
Could that solve this?
I have seen some obd cables, with 2 needles.
I also found this tool:
https://www.ryansautomotive.ie/shop/...iat-fca-group/
Results 1 to 4 of 4
-
5th February, 2021, 09:31 PM #1DK Veteran
- Join Date
- May 2011
- Posts
- 4,825
- Thanks
- 2,030
- Thanks
- 2,231
- Thanked in
- 1,566 Posts
FCA 2018+ gateway bypass leaving dtc
Last edited by rob h; 5th February, 2021 at 09:49 PM.
-
6th February, 2021, 02:27 AM #2Senior Member
- Join Date
- May 2010
- Location
- here
- Posts
- 264
- Thanks
- 128
- Thanks
- 43
- Thanked in
- 36 Posts
No worries, just don't use that adapter and don't disconnect the CGW.
Run two CAN wires from the scanner to the can-bus breakout adapter and take power/ground to power up the tool from obd 2.
Sent from my HD1905 using Tapatalk
-
The Following User Says Thank You to fixanycar For This Useful Post:
rob h (6th February, 2021)
-
6th February, 2021, 03:02 AM #3DK Veteran
- Join Date
- Oct 2009
- Posts
- 1,452
- Thanks
- 248
- Thanks
- 364
- Thanked in
- 153 Posts
If you connect the diagnostics after the gateway and leaving it connected to the network you shouldnt be having fault codes about missing gateway right???
-
6th February, 2021, 06:02 PM #4DK Veteran
- Join Date
- May 2011
- Posts
- 4,825
- Thanks
- 2,030
- Thanks
- 2,231
- Thanked in
- 1,566 Posts
I Will try the Fixanycar method.
Thank you
Reply With Quote
Bookmarks