I bought it from Race Automobile Technology.
My lights ?
I bought it from Race Automobile Technology.
My lights ?
I did not solve it yet..
They agreed to send me another cable yesterday.
They are in China, and i am in Norway so it will take some time.
Also very strange, i try to run the c?sar self diagnosis test and it shows up folowing error.
ERROR: device '0 (-1) isn't in state available
Device: Part D
Toolkit-Resultcode: -1
The MUX are connected to the car and the LED lights up.
But it works fine with connected to W210 with old cable and not with new 16 pin ODB cable.
I also have the same problem like you with caesar selfdiagnosis test on SDS 11.2010. Did you solve it? Any solution for that?
Anyway, I can diagnosis all cars normally.
I have one more problem with DAS. After programming an module, at the end of the programming i get an error message about DAS32R2.exe and CAL_REAL.dll error, and DAS closes abnormally. How can i fix that?
Regards
hello,
i have burned R12 /near ellyt/ on multiplexer board in last C3 clone /from carsung/ after conect to 24v.
can help somebody with resistor value please?
wbr
peter
Last edited by PeterOBD; 1st July, 2011 at 04:59 AM.
hi. my the latest job with mb star was at truck actros. all goes well. after that can not connecting at any vehicles. checked cables and open diag but can not see anything damaged visual. my diagnostic have not more then 10 working h. it new. tried find parts which member Bigovic suggesting but can not. friend Bigovic can you circle parts which i maybe have to change
here picture of my boards
mb star c3.jpg boards.jpg message.jpg
6841707059 576F526B 57416E5453 596F55 526F6B69424152
Bookmarks